Reebok T7.90 Elliptical English Manual - Page 11

10. Attach the Left Link Arm (30) to the Left Pedal Arm (32) with an M8 x 15mm Button Screw 10 24 (106), an M8.5 x 16mm x 1.5mm Washer (103), and an Axle Cover (66). 31 106 Attach the Left Link Arm (30) to the left Upper Body Leg (24) with an M8 x 25mm Button Screw (110), two M8.5 x 16mm x 1.5mm Washers (103), two Axle Covers (66), a Link Arm Spacer (74), and an M8 x 15mm Button Screw (106) as shown. 66 74 103 110 103 66 30 Attach the Right Link Arm (31) in the same way. 106 103 66 32 11. The Console (11) can use four D batteries (not included); alkaline batteries are recommended. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries. Otherwise, you may damage the console displays or other electronic components. Remove the battery cover, insert the batteries into the battery compartment, and reattach the battery cover. Make sure to orient the batteries as shown by the diagram inside the battery compartment. To purchase an optional AC adapter, contact the store where you purchased this product or call the telephone number on the cover of this manual. To avoid damaging the console, use only a manufacturer-supplied AC adapter. Plug one end of the power supply into the jack on the front of the elliptical exerciser; plug the other end into an outlet installed in accordance with all local codes and ordinances. 11 11 Battery Cover Battery Cover 12. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 11