Ricoh P 502 User Guide - Page 102
Parallel I/F Error, Problem with Hard Disk
View all Ricoh P 502 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
5. Troubleshooting Message Cause Solution "IPv6 Address already exists The same IPv6 address is already Stateless used. Address(109/209)" Contact your network administrator. "IPv6 Address already exists The same IPv6 address is already Manual Config. used. Address(109/209)" Contact your network administrator. "Load paper in (tray name)" There is no paper in the specified tray. Load the specified paper in the tray, press [JobReset] to reset the job. "No privileges to use funct." The logged in user does not have the privileges to register programs or change the paper tray settings. For details about how to set permissions, see Security. "Option RAM Error" The machine cannot detect an optional SDRAM module. Check that the SDRAM module installed correctly. "Parallel I/F Error" The machine's self-diagnostic test Replace the IEEE 1284 board that failed due to a loopback error. caused the error. "Printer Font Error." There are problems with the machine's font file. Turn the machine off, and then turn it on again. If the problem persists, contact your sales or service representative. "Problem with Hard Disk Please call service." The machine cannot detect the hard disk. Check that the hard disk installed correctly. If the problem persists, contact your sales or service representative. "Problem:Wireless card Please call service." The machine cannot detect a wireless LAN interface board. Check that the wireless LAN interface board installed correctly. If the problem persists, contact your sales or service representative. 100