Ricoh P 502 User Guide - Page 104
For details, see Adding Toner, The same IPv4 Address
View all Ricoh P 502 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
5. Troubleshooting Message Cause Solution "Set the Print Cartridge correctly." The print cartridge may have not Turn the machine off, and install been installed correctly. the print cartridge again. "Standard Tray is full. Remove the paper." The standard tray is full. Remove the paper. "Supply order has failed." The automatic supply order failed. The message indicates the machine tried to order the supplies. "This NetBIOS name is already in use.(108/208)" The NetBIOS name specified for the machine is already used by another device on the network. Contact your network administrator. "The same IPv4 Address already exists.(102/202)" The IPv4 address specified for the machine is already used by another device on the network. Contact your network administrator. "The selected job has already been printed or deleted." This message might appear if you print or delete a job by using a web browser on a networked computer. Press Exit on the message screen. "USB has a problem." The machine has detected a USB board failure. Turn the machine off, and then turn it on again. If the problem persists, contact your sales or service representative. "Values set for IPv6/ Gateway addresses are invalid.(110/210)" The IPv6 address or gateway address is invalid. Check the network settings. "Waste Toner almost full" The waste toner in the print cartridge is almost full. Prepare a new print cartridge. "Waste Toner Full" The waste toner in the print cartridge is full. Replace the print cartridge. For details, see "Adding Toner", Maintenance. "WPA Auth. incomplete. (211)" WPA authentication could not be Contact your network completed. administrator. 102