Ridgid 1822-I Owners Manual - Page 22
Spindle Conversion Kit for, Plastic Coated Pipe
View all Ridgid 1822-I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
1822-I Pipe and Bolt Threading Machine Figure 23A - Remove Jaw Insert Figure 24 - Reinstall Rear Jaws and Spacers on Rods 6. Reinstall rear retainer and retaining clips. Spindle Conversion Kit for Plastic Coated Pipe Figure 23B - Remove Jaw Insert 5. Reinstall jaw insert and finger, and tighten screw. Rear Centering Finger/Jaw Replacement 1. With rear centering jaw in the OPEN position unplug machine and remove rear cover. 2. Remove three e-clips holding rear retainer in place and remove retainer. (Refer to Figure 26 Step 1.) 3. Remove spacers and rear centering jaws. 4. On a workbench, drive out pins holding centering finger in place and install new centering finger. 5. Reinstall rear jaws and spacers on rods. (Refer to Figure 24.) Locate square pin in jaw slot. Figure 25 - PCP Kit Spindle Assembly Removal 1. With machine OFF and unplugged, remove front and top covers. 2. Remove rear centering assembly. 3. Remove three (3) brake shoes. (Refer to Figure 26.) 4. Remove small E-clips and washers holding front jaws to drive sprocket. Slide out spindle assembly. Spindle Assembly Installation 1. Following reverse procedure, install new spindle as- sembly for plastic coated pipe. 20 Ridge Tool Company