Ridgid 1822-I Owners Manual - Page 23
Machine Storage
View all Ridgid 1822-I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
1822-I Pipe and Bolt Threading Machine 2. Install the E-clips and washers on the front jaws. 3. Reassemble the three (3) brake shoes. NOTE! Tighten shoulder bolts until they bottom out. 4. Reassemble rear centering assembly using new spacers and rear jaws supplied with the kit. NOTE! Rear jaws must be oriented as shown for right hand threading. (Refer to Figure 27.) 5. Install top and front covers. WARNING Do not operate machine with covers removed. NOTE! Once the machine is fitted with the new kit to thread plastic coated pipe, it is also capable of threading steel and galvanized pipe sizes 1/2″ - 2″. If smaller sizes than 1/2″ pipe are required, the original front and rear jaw assemblies must be installed. Step 1 Step 2 Figure 27A - Jaw Orientation Figure 26 - Removing Brake Shoes Step 3 Figure 27B - Jaw Orientation Machine Storage WARNING Motor-driven equipment must be kept indoors or well covered in rainy weather. Store the machine in a locked area that is out of reach of children and people unfamiliar with threading machines. This machine can cause serious injury in the hands of untrained users. Ridge Tool Company 21