Ridgid 1822-I Owners Manual - Page 9
Mounting Machine to No. 1406 Folding
View all Ridgid 1822-I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
1822-I Pipe and Bolt Threading Machine Mounting Machine to No. 1406 Folding Wheel Stand 1. Raise rear handle of stand to a vertical position and tighten mounting bolts. 2. Using hand crank, raise stand to its operating height. Place machine on stand with carriage away from wheels (Figure 4). Insert four 1/4″ - 20 bolts through rails into machine base. Tighten bolts. Installing No. 1460 Oil Pan Cover NOTE! No. 1460 Oil Pan Cover installs in machine oil reservoir and prevents oil spill during transportation. No. 1460 is shipped with No. 1406 Folding Wheel Stand and is available as an accessory. 1. With oil reservoir drained, disconnect filter and oil line. 2. Attach elbow fitting and oil line extension to existing oil line (Figure 5A). 3. Reattach oil line to filter and the filter to reservoir base. 4. Install oil pan cover with oil line positioned as in Figure 5B. 5. Set chip pan in place and machine is ready for transport. NOTE! Chip pan will not lock into position. This is a reminder that the oil pan cover is installed. Line Extension Oil Filter Elbow Fitting Figure 5A - No. 1460 Oil Pan Cover Push Rear Latch Oil Line Notch Oil Pan Cover Front Latch Figure 5B - No. 1460 Oil Pan Cover Mounting Machine To Bench 1. If a stand is not used, the machine should be mounted to a stable bench. To mount the unit on a bench, use four (4) 5/16″ bolts in holes provided at each corner of machine base. Base dimensions are shown in Figure 2. WARNING Failure to mount the threading machine to a stable stand or bench may result in tipping and serious injury. Transporting Machine with No. 1406 Stand 1. Install 1460 Oil Pan Cover to prevent oil spillage. 2. For ease of transporting, turn hand crank counterclockwise and fold stand into a compact package. 3. Lift handles (front and rear) and skid bars are provided for transportation on stairways, over rough terrain and in and out of trucks, vans and station wagons. WARNING Use two persons on stairs. 4. The front handle is for control on stairs and wheelbarrow like operation. 5. The rear handle is for an assist on stairs, lifting in and out of vehicles and movement over flat surfaces in the operational position. Transporting Machine with a Tow Motor, Material Lift or Crane 1. Place tow motor forks below base of machine and above cabinet or tray. 2. Loop a sling over a 2″ piece of pipe as shown in Figure 6 and lift machine with a lift or crane. 3. Place a sling around machine and top stand rails and lift machine with a material lift or crane. Ridge Tool Company 7