Ridgid RD8000 Owners Manual - Page 10
Features - operators manual
View all Ridgid RD8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
FEATURES PRODUCT SPECIFICATIONS Engine Engine Type Subaru, EX40 OHC Bore x Stroke 89 mm x 65 mm Cooling System Forced Air Compression Ratio 8:1:1 Starting System Recoil & Electric Ignition System T.C.I. Spark Plug NGK BR6HS Engine Lubricant Volume 1.2 qt. Fuel Volume 8 gal. Generator Rated Voltage 120V/240V Rated Amps 66.7 A / 33.3A Rated Output 8,000 W Maximum Output 10,000 W Rated Frequency 60 Hz Dimensions Length 31 in. Width 30 in. Height 27 in. Weight 256 lbs. KNOW YOUR GENERATOR See Figure 3. The safe use of this product requires an understanding of the information on the product and in this operator's manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules. AC circuit breaker The circuit breaker is provided to protect the generator against electrical overload. The circuit breaker may be reset by pressing the circuit breaker reset button. and alerts the operator when periodic engine maintenance is recommended. NOTE: GenSmart™ load indicators monitor the load only for the 120 Volt, 20 Amp GFCI outlets on the removable control panel. It does not measure load on the 240 Volt, 30 Amp outlet. ground terminal The ground terminal is used to assist in properly grounding the generator to help protect against electrical shock. Consult with a local electrician for grounding requirements in your area. air filter The air filter helps to limit the amount of dirt and dust drawn into the unit during operation. OFF switch To turn the engine off, press and hold the off switch until the engine stops. choke lever The choke lever is used when starting the engine. engine switch with switch key The engine switch is used in combination with the recoil starter grip to start the generator. To turn the engine off, turn the engine switch key to "OFF". oil cap/dipstick Remove the oil fill cap to check and add lubricant to the generator when necessary. oil drainage bolt When changing the engine lubricant, the oil drainage bolt is loosened to allow old engine lubricant to be drained. extension cord The 25-ft. extension cord (Model # RDEC25) has a 120/240 Volt, 20 Amp twist lock plug and a 12 Volt DC engine control connector on each end. When using this cord with the removable control panel, appropriate equipment can be powered through the 2 x 120 Volt duplex GFCI outlets on the removable control panel. fuel tank with fuel GUAGE The fuel tank with fuel guage has a capacity of 8 gallons. fuel valve The flow of fuel through the generator is controlled by the position of the fuel valve. GenSmart™ monitoring system The GenSmart monitoring system tracks usage and load receptacleS The following single phase, 60 Hz outlets on the control panel can be used for operating appropriate equipment, electrical lighting, tools, and motor loads: 2 x 120 Volt duplex GFCI 20 Amp receptacles, and one 240 Volt AC, 30 Amp receptacle. A 240 Volt AC, 20 Amp receptacle plugged into the side of the removable control panel is available when the panel is detached. recoil starter grip The recoil starter is pulled to start the machine. removable control panel The removable control panel can be wall-mounted for use with extension cords for operation in a variety of locations. 10 - English