Ridgid WD1270 Owners Manual - Page 8

SP6765-2 12 GALLON ES 2/3/12 2:00 PM Page 8 Operation (continued) To reduce the risk of electric shock, this Vac has a polarized plug (one blade is wider than the other except 230 volt models). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. After you plug the power cord into the outlet, turn the unit on by pushing the switch from position "O" to position "l". The symbols used on the switch actuator are international "On & Off" symbols: Vacuuming Dry Materials 1. The filter must always be in correct position at all times to avoid leaks and possible damage to Vac. 2. Your using your Vac to pick up very fine dust, it will be necessary for you to empty the drum and clean the filter at more frequent intervals to maintain peak Vac performance. NOTE: A dry filter is necessary to pick up dry material. If you use your Vac to pick up material when the filter is wet, the filter will clog quickly and be very difficult to clean. = OFF = ON Vacuuming Liquids Familiarize yourself with the accessories included with the Vac. Each accessory may be used in various ways for vacuuming and blowing debris. Here is a list of the accessories and their uses. Utility Nozzle - General purpose nozzle for most vacuuming applications. Car Nozzle - Dry pickup nozzle for car interiors and most upholstery cleaning. Wet Nozzle - Used for wet pickup on smooth surfaces to pick up liquid and dry the surface in one stroke. Extension Wands - These wands can be connected together and provides additional length for more reach. Dual-Flex™ Locking Hose - Provides transfer of vacuum or blowing capability to work site. Provides the means of attaching extension wands and nozzles. 1. When picking up small amounts of liquid the filter may be left in place. 2. When picking up large amounts of liquid we recommend that the filter be removed. If the filter is not removed, it will become saturated and misting may appear in the exhaust. 3. When the liquid in the drum reaches a predetermined level, the float mechanism will rise automatically to cut off air-flow. You will know that the float has risen because Vac airflow ceases and the motor noise will become higher in pitch, due to increased motor speed. When this happens, turn off the Vac, unplug the power cord, and empty the drum. 4. After using the Vac to pick up liquids, the filter must be dried to avoid possible mildew and damage to the filter. IMPORTANT: To reduce the risk of damage to the Vac, do not run motor with float in raised position. 8