Rocketfish RF-RBUSB User Manual (English) - Page 22
Using your wireless sender/receiver as a sender
View all Rocketfish RF-RBUSB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
6 Press and hold the on the Rocketboost hub device for more than three seconds to put it into joining mode. The power indicator starts blinking rapidly and the unit will stay in joining mode for 30 seconds. The diagram (below) shows an example of this. In this example, the wireless sender/receiver is the hub device. Power on indicator 7 Press and hold the on your other Rocketboost device for more than three seconds to put it into joining mode. • When successfully joined, the power indicator LEDs on both products will stop blinking and stay on. • If joining fails after 30 seconds, the power indicator LEDs will begin flashing at a slower rate. If this occurs, repeat the above steps. • Repeat steps 2-7 for each additional Rocketboost device you are adding to your network. Using your wireless sender/receiver as a sender Note: When using the wireless sender/receiver as a sender, the Sender mode indicator LED will light when you are correctly connected to an audio source. To use your wireless sender/receiver as a sender: 1 Turn on the audio source connected to the wireless sender/receiver. Make sure the volume of the audio source is turned up and not muted, otherwise no audio will be sent over the Rocketboost network. 2 Select either USB-In or LINE-In using the remote control, depending on which audio input you are using. 22