Rocketfish RF-RBWS02 User Manual (English) - Page 23

Joining the sender/receiver and wireless speaker to an existing Rocketboost network

Get Rocketfish RF-RBWS02 PDF manuals and user guides View all Rocketfish RF-RBWS02 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

3 Press and hold the button on the wireless speaker for more than three seconds so the sender/receiver and wireless speaker enter joining mode. POWER /JOIN BASS CHARGE CHANNEL L - MONO - R SOURCE TM Power on indicator • The power indicators light steadily if the joining was successful. • The power indicators blink slowly if the joining was not successful. Note: Rocketboost devices have their own memory. After the devices are joined once, they will remember each other and join automatically when your devices are powered on again. Because of this, you can join all of your network components in the same room before installing them in their permanent locations throughout the house. Joining the sender/receiver and wireless speaker to an existing Rocketboost network Use this procedure only if you are adding this product to an existing Rocketboost network. You need to join both the sender/receiver and the wireless speaker to your existing hub device, using the following steps. RF-RBWS02 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
23
RF-RBWS02
3
Press and hold the
button on the wireless speaker for more than three
seconds so the sender/receiver and wireless speaker enter joining mode.
•
The power indicators light steadily if the joining was successful.
•
The power indicators blink slowly if the joining was not successful.
Note
: Rocketboost devices have their own memory. After the devices are joined once,
they will remember each other and join automatically when your devices are
powered on again. Because of this, you can join all of your network components in
the same room before installing them in their permanent locations throughout the
house.
Joining the sender/receiver and wireless speaker to an
existing Rocketboost network
Use this procedure only if you are adding this product to an existing
Rocketboost network.
You need to join both the sender/receiver and the wireless speaker to
your existing hub device, using the following steps.
Power on
indicator