Ryobi JS550LK English Manual - Page 10

UNPACKING This tool has been shipped completely assembled except for the blade.  Carefully remove the tool and accessories from the box.  Make sure that all items listed in the packing list are included.  Inspect the tool carefully to make sure no breakage or damage occurred during shipping.  Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool.  If any parts are damaged or missing, please call 1-800-525-2579 for assistance. PACKING LIST Variable Speed Orbital Jig Saw Blades (2) Vacuum Attachment Edge Guide Case Operator's Manual WARNING: If any parts are missing do not operate your tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury. ASSEMBLY WARNING: Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious personal injury. TO INSTALL JIG SAW BLADES See Figure 2.  Unplug your saw. � Lift the clamping lever on the rapid-change blade clamp until it stops. � Holding the clamping lever up, insert the saw blade as far as possible into the slot in the saw bar. � Check to make sure the back of the saw blade is centered in the groove of the roller guide. � Release the clamping lever. Make sure the blade is securely in place. DUST PICK-UP FEATURE See Figure 3. For dust pick-up operation, a vacuum attachment has been provided with the saw. It attaches to the saw base. To Install:  Unplug the saw.  Slide the vacuum attachment into the curved area at the rear of the saw base until it snaps into place.  Attach vacuum attachment to a 1-1/4 in. vacuum hose. � Connect vacuum hose to cleaner. To Remove:  �Unplug the saw. � Remove the vacuum attachment by pulling attachment from base. 10 CLAMPING LEVER SAW BLADE Fig. 2 VACUUM ATTACHMENT Fig. 3