Ryobi PSP02K Operation Manual - Page 10
Maintenance
View all Ryobi PSP02K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
MAINTENANCE WARNING: To avoid serious personal injury, always remove the battery pack from the tool when cleaning or performing any maintenance. WARNING: Always wear eye protection with side shields or goggles marked to comply with ANSI Z87.1. Failure to do so could result in fluids entering your eyes resulting in possible serious injury. WARNING: When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage. NOTICE: Periodically inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product until all missing or damaged parts are replaced. Please contact customer service or a qualified service center for assistance. GENERAL MAINTENANCE Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and can be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc. CLEANING THE UNIT WARNING: Always store and dispose of chemicals properly. Disposal of contaminated rinse water should be performed according to local ordinances and bylaws. DRAINING THE TANK If there is any liquid left in the tank after spraying, the tank should be drained before cleaning. Remove the battery pack. Remove the tank and unscrew the cap. Drain the contents of the tank through the fill area. NOTE: Drain the contents back into the original container. Do not store chemicals in the tank. CLEANING THE TANK AND SPRAY LINES Fill the tank about one-third full with clean water. A small amount of mild household detergent may be added. NOTE: Never use flammable chemicals or abrasive cleaning agents to clean the tank. Wipe the outside of the tank with a clean, dry cloth. Replace the cap. Reinstall the tank and latch to secure. Reinstall the battery pack. Spray until the tank has been emptied. Make sure to direct the spray toward an area that will not be damaged by the spray solution. Refill and repeat the procedure with clean water. It may be necessary to rinse the tank more than once, then drain again as directed above. Allow all pieces to completely dry before reinstalling parts and storing the unit. NOTE: Store the sprayer in an upright position. DO NOT store the sprayer on its side. WARNING: Do not at any time let brake fluids, gasoline, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken, or destroy plastic which may result in serious personal injury. 10 - English