Ryobi PSP02K Operation Manual - Page 7

OPERATION WARNING: Use safety equipment. Protect your eyes, skin, and lungs while mixing, filling, spraying, and cleaning. Failure to do so may result in serious personal injury and damage to property. CAUTION: Wear shoes with a leather sole while using this sprayer. Do not wear shoes with a rubber sole, or similar insulating footwear. NOTICE: Before each use, inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product until all missing or damaged parts are replaced. Please contact customer service or a qualified service center for assistance. APPLICATIONS You may use this product for the purposes listed below:  For use with industrial and consumer grade disinfecting chemicals  Applying disinfectant solutions in professional, medical, and custodial settings and a variety of other industrial applications INSERTING AND REMOVING THE NOZZLE See Figure 1, page 13.  Turn electrostatic function off and remove the battery from the unit.  Rotate the dial so the nozzle you are going to insert or remove is in the 6 o'clock position. To insert:  Insert the nozzle (with o-ring) into the front of the nozzle dial.  Rotate the nozzle clockwise until the o-ring is sealed against the face of the mode selector. Do not over-tighten. To remove:  Rotate the nozzle counterclockwise and remove the nozzle (with o-ring) from the mode selector. USING THE MODE SELECTOR See Figure 2, page 13. The sprayer has three spray modes and a prime mode. Rotate the mode selector to choose the appropriate mode. NOTE: When one of the spray modes is selected, the word "SPRAY" will appear in the indicator window. When the prime mode is selected, "PRIME" will appear in the indicator window.  PRIME - Select this mode and squeeze the trigger to draw liquid from the tank and through the lines to create a consistent spray.  SPRAY (50 Microns) - Select this mode to create a spray made up of small droplets that absorb quickly.  SPRAY (75 Microns) - Select this mode to create a spray made up of medium sized droplets.  SPRAY (100 Microns) - Select this mode to create a spray made up of large droplets that absorb slowly. NOTE: Select the correct nozzle for optimal performance. Some products become less effective if absorbed too quickly or too slowly. Refer to the manufacturer's instructions for the product you are spraying. NOTE: If nozzles become clogged, see instructions in Maintenance section to clear blockage. FILLING THE TANK See Figures 3 - 5, pages 13. WARNING: Before filling the tank, always remove the battery pack. Turn electrostatic function off before removing the battery from the unit. Wipe up any spills before inserting the battery pack. Following this rule will reduce the risk of electric shock and corrosive liquids entering the battery pack, which can cause battery pack failure including short circuit resulting in smoke, fire, and/or serious personal injury. WARNING: Always follow the chemical manufacturer's instructions printed on their product labeling for use, cleaning, and storage. Do not combine chemicals. Clean thoroughly after each use, following the instructions in the Maintenance section of this manual. Chemicals should be stored out of the reach of children. Failure to do so may result in serious personal injury. 7 - English