Ryobi RYi2200A User Manual - Page 13
Generator Capacity, Power Management
View all Ryobi RYi2200A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ELECTRICAL GENERATOR CAPACITY Make sure the generator can supply enough continuous (running) and surge (starting) watts for the items you will power at the same time. Follow these simple steps. 1. Select the items you will power at the same time. 2. Total the continuous (running) watts of these items. This is the amount of power the generator must produce to keep the items running. See the wattage reference chart at right. 3. Estimate how many surge (starting) watts you will need. Surge wattage is the short burst of power needed to start electric motor-driven tools or appliances such as a circular saw or refrigerator. Because not all motors start at the same time, total surge watts can be estimated by adding only the item(s) with the highest additional surge watts to the total rated watts from step 2. Example: Tool or Appliance RV Air Conditioner (11,000 BTU) TV (Tube Type) RV Refrigerator Radio Light (75 Watts) Coffee Maker Running Watts* 1010 300 180 200 300 600 2590 Total Running Watts Starting Watts* 1600 0 600 0 0 0 1600 Highest Starting Watts Total Running Watts Highest Starting Watts Total Starting Watts Needed 2590 + 1600 4190 POWER MANAGEMENT To prolong the life of the generator and attached devices, it is important to take care when adding electrical loads to the generator. There should be nothing connected to the generator outlets before starting its engine. The correct and safe way to manage generator power is to sequentially add loads as follows: 1. With nothing connected to the generator, start the engine as described later in this manual. 2. Plug in and turn on the first load, preferably the largest load you have. 3. Permit the generator output to stabilize (engine runs smoothly and attached device operates properly). 4. Plug in and turn on the next load. 5. Again, permit the generator to stabilize. 6. Repeat steps 4 and 5 for each additional load. Never add more loads than the generator capacity. Take special care to consider surge loads in generator capacity as previously described. NOTICE: Do not overload the generator's capacity. Exceeding the generator's wattage/amperage capacity may damage the generator and/or electrical devices connected to it. Tool or Appliance Estimated Running Watts* Estimated Starting Watts* Home / Emergency Incandescent Lights (4 Quantity x 75 Watts) 300 0 TV (Tube Type) 300 0 Sump Pump (1/3 hp) 800 1300 Refrigerator or Freezer 700 2200 Well Pump (1/3 hp) 1000 2000 Furnace (1/2 hp) 800 2350 Radio 200 0 Tools Drill (3/8", 4 amps) 440 600 Circular Saw (Heavy Duty, 7-1/4") 1400 2300 Recip Saw 960 960 Miter Saw (10") 1800 1800 Table Saw (10" ) 2000 2000 *Wattages listed are approximate. Check tool or equipment for actual wattage. Page 9 - English