Samsung 9.1.2ch Soundbar w/ Wireless Dolby Atmos / DTS:X and Rear Speakers 2022 - Page 18
Check if the LINK LED is solid blue connection complete, If the SWA-9100 does not connect
View all Samsung 9.1.2ch Soundbar w/ Wireless Dolby Atmos / DTS:X and Rear Speakers 2022 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
4. Check if the LINK LED is solid blue (connection complete) STANDBY STANDBY LINK LINK The LINK LED indicator stops blinking and glows a solid blue when a connection is established between the Soundbar and the Wireless Receiver Module. Blue is On 5. If the SWA-9100 does not connect, take the necessary steps according to the LED Indicator's status LINK (Blue) LED status On Connected with the Soundbar Blinking Connection standby status STANDBY (Red) On Connection failure Action Check if the Soundbar is turned on Repeat steps 3 through 4. Check if the Soundbar is turned on 1. Press the ID SET button on the back of the Wireless Receiver Module with a pen tip for 5~6 seconds until the LINK LED indicator blinks (in Blue). SURROUND SPEAKERS OUT SL PEAR KER IMPEDANCE : 3Ω 5 Sec SURROUND SPEAKERS OUT SPEAKER IMPEDANCE : 3Ω ID SET ID SET Others - Errors 2. Repeat stePpOsW3ERthrough 4. Contact a Samsung Service Center. POWER ENG - 18