Samsung DMT400RHS Installation Guide Ver.1.0 (English, French, Spanish) - Page 19

02 INSTALLING THE DISHWASHER 3. Check the size of the sink's drain hose connector. If needed, cut the drain hose so its end fits onto the sink connector (½ in., ¾ in. or 1 in. - as shown in Figure 11 below). If the end of the drain hose does not fit onto the drain hose connector of the sink, use an adaptor purchasable at a plumbing/hardware supply store. 4. Slide a hose clamp over the end of the drain hose. Attach the drain hose to the sink connector, slide the hose clamp to the end of the hose, and then tighten the hose clamp. Note : You must use a hose clamp. Failure to do so may cause water leakage. 5 . If there is no air gap, make sure to hang. the middle of the drain hose well above the sink cabinet base to prevent backflow (see Figure 12 below). Be careful when cutting off the end of the drain hose as there is a risk of injury. Clean CAUTION around the sink's drain connection so that it does not damage the hose. Check for any foreign items in the drain hose and remove them. 1 in. ¾ in. ½ in. (25 mm) (19 mm) (13 mm) If required, cut off the end of the drain hose at one of the dotted lines. Sink Drain hose Min. 30 in. (762 mm) Min. 20 in. (508 mm) Dishwasher installation_DD68-00046A-06_EN_130401.indd Sec3:19 installing the dishwasher _19 2013-04-01 5:05:24