Samsung DVG50R5400W/A3 User Manual - Page 52

Care, Wrinkle, Prevent Wrinkle

Get Samsung DVG50R5400W/A3 PDF manuals and user guides View all Samsung DVG50R5400W/A3 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 52 highlights

Troubleshooting Problem Has odors. Lint on clothes. Items still wrinkled after WRINKLE PREVENT (WRINKLECARE, WRINKLE RELEASE). Water drips from the nozzle when STEAM CARE starts. Sprayed water is not visible during STEAM CARE. Extended time. Action • Household odors from paint, varnish, strong cleaners, etc. may enter the dryer with the surrounding room air. This is normal as the dryer draws the air from the room, heats it, pulls it through the tumbler, and exhausts it outside. • When these odors linger in the air, completely ventilate the room before using the dryer. • Use a cycle featuring the Refresh function. If odors persist, wash and dry the item again. • Use the REFRESH cycle (DVE(G)50R5400* models only). If odors persist, wash and dry the items again. • Make sure the lint filter is cleaned before every load. For clothes that naturally build up lint, clean the filter during the cycle. • Some fabrics are lint producers (for example, a fuzzy white cotton towel) and they must be dried separately from clothes that are lint trappers (for example, a pair of black linen pants). • Divide larger loads into smaller loads for drying. • Check pockets thoroughly before drying, then dry clothes. • Remove lint inside the drum before drying. • Small loads of 1 to 4 items work best. • Load fewer items. Load similar-type items. • Take out the items immediately after drying is complete. • This is steam condensation. The dripping water will stop after a short time. • Sprayed water is difficult to see when the door is closed. • Sensor Dry automatically senses the moisture in the load and shuts the dryer off when the selected dryness level is reached. The drying time can change according to the type and amount of laundry. See the cycle chart for reference. If a problem persists, contact a local Samsung service center. Troubleshooting 52 English Untitled-16 52 2020-07-14 3:36:22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
Troubleshooting
English
52
Troubleshooting
Problem
Action
Has odors.
•
Household odors from paint, varnish, strong cleaners, etc.
may enter the dryer with the surrounding room air. This is
normal as the dryer draws the air from the room, heats it,
pulls it through the tumbler, and exhausts it outside.
•
When these odors linger in the air, completely ventilate the
room before using the dryer.
•
Use a cycle featuring the Refresh function. If odors persist,
wash and dry the item again.
• Use the
REFRESH
cycle (DVE(G)50R5400* models only). If
odors persist, wash and dry the items again.
Lint on clothes.
•
Make sure the lint filter is cleaned before every load. For
clothes that naturally build up lint, clean the filter during
the cycle.
•
Some fabrics are lint producers (for example, a fuzzy white
cotton towel) and they must be dried separately from
clothes that are lint trappers (for example, a pair of black
linen pants).
•
Divide larger loads into smaller loads for drying.
•
Check pockets thoroughly before drying, then dry clothes.
•
Remove lint inside the drum before drying.
Items still wrinkled
after WRINKLE
PREVENT (WRINKLE-
CARE, WRINKLE
RELEASE).
•
Small loads of 1 to 4 items work best.
•
Load fewer items. Load similar-type items.
•
Take out the items immediately after drying is complete.
Water drips from the
nozzle when STEAM
CARE starts.
•
This is steam condensation. The dripping water will stop
after a short time.
Sprayed water is not
visible during STEAM
CARE.
•
Sprayed water is difficult to see when the door is closed.
Extended time.
•
Sensor Dry automatically senses the moisture in the load
and shuts the dryer off when the selected dryness level is
reached. The drying time can change according to the type
and amount of laundry. See the cycle chart for reference.
If a problem persists, contact a local Samsung service center.
Untitled-16
52
2020-07-14
°° 3:36:22