Samsung RF4289HARS Quick Guide (easy Manual) (ver.1.0) (English) - Page 7

Accessories and required tools The following accessories are included with your refigerator: • Reattach the door/drawer properly to avoid: - Moisture from air leakage. - Uneven door alignment. - Wasting energy due to improper door seal. Hex wrench Fastener Compression Compression fitting nut Required Tools (Not provided) You need the following tools to complete the installation of your refirgerator: Disassemble the refrigerator doors Be careful not to drop and scratch the doors WARNING while removing the doors. Disassemble the refrigerator doors 1. With the door opened, remove the cap top table ( 1 ) with a flat-blade screwdriver (-), and close the door. Remove the 3 screws holding down the top table ( 2 ) and turn it with several wires connected. 01 setting up Philips screwdriver (+) Flat-blade screwdriver (-) Socket wrench (10mm) Pliers Allen wrench (3/16") (5mm) 2 1 Removing the refrigerator doors 2. Disconnect one connector ( 3 ) on the right side door and one connector ( 4 ) on the left side door. Remove the water line ( 5 ) while pressing the dark gray color part ( 6 ) of the water line coupler. Some installations require door removal to transport 4 the refrigerator to its final location. Do not remove the door/drawer if you don't need to. Red Clip (1/4") 3 If you do not need to remove the refrigerator doors, go to Adjusting the Level on page 8. If you need to remove the doors. continue below. Before removing the door/drawer, make sure you read 5 the following items: 6 Disconnect power to the refrigerator before WARNING removing the door or drawer. • Be careful not to drop, damage or scratch the door/drawer while removing them. • Be careful not to get injured while removing the door/drawer. If a red clip is on the coupler, it must be caution removed before removing the tube. setting up _07