Samsung SPL4225 User Manual (user Manual) (ver.1.0) (English) - Page 8

Wall Installation Instructions Installation Notes 1 Do not install the PDP in any location other than vertical walls. 2 To protect the performance of the PDP and prevent problems, avoid the following places: • Do not install next to smoke and fire detectors. • Do not install in an area subjected to vibration. • Do not install in an area subjected to high voltage. • Do not install near or around any heating apparatus. 3 Use only recommended parts and components. Parts (Wall attachment panel is sold separately. Check with your dealer) Wall attachment panel 34.61 inches 24.57 inches bolt Insulation holder 14 Installing the Display on the Wall Attachment Panel 1 See the drawing of the wall attachment panel shown in page 14 to check for the stability of the wall where the PDP is to be installed. If the wall is not enough strong to support the PDP, strengthen the wall before installation. 2 Fix the wall attachment panel on the wall using bolts as shown in the following figure: Fixing bolts must protrude from the wall appox. 0.6 inches. 3 Using the wall attachment panel, you may adjust the angle of the display from 0 to 20 degrees. The angle can be set in 5 stages with 5 degrees of distance each, using the angle control holes on the sides of the panel. When the angle has been set to 5 degrees. When the angle has been set to 15 degrees. When the panel hasn't been tilted. Angle control holes 5 degrees of tilt 10 degrees of tilt 15 degrees of tilt 20 degrees of tilt No tilt Continued... 15