Samsung WA40J3000AW/A2 User Manual - Page 15
Connecting the drain hose, Leveling your washer
View all Samsung WA40J3000AW/A2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
01 installing your washer Connecting the drain hose The end of the drain hose can be positioned in three ways: Over the edge of a wash basin Secure the guide to the side of the basin wall with a hook or to the tap with a piece of string to prevent the drain hose from moving. In a standpipe or laundry tub The standpipe must be no shorter than 39 in (99 cm) and no longer than 96 in (245 cm). Make sure that the connection between the drain hose and the standpipe is not airtight. Laundry tub 96" Max 39" Min Standpipe Hose retainer Tie strap 39" Min (99 cm) Connect the hose guide no more than 4 in (10cm) from the end of the drain hose. If the drain hose extends more than 4 in (10cm) beyond the end of the hose guide, mold or microorganisms could spread to the inside of the washer. 1RPRUHWKDQ The Drain Hose can be installed up to 96 in (245cm) above the floor, but the draining capability can be LQFP reduced at this height. This can cause the washer to have an odor because of water remaining in the drain +RVH*XLGH system. If the drain hose is installed below 39 in (99cm), water can drain during wash cycles due to a siphon effect. If this occurs, it causes the Tap cold LED on the washer to flash. STEP 3 Leveling your washer See if the washer is level by checking the position of the tub: 1. Slide the washer into position. 2. Open the lid of the washer, and pour the water into the tub to just below the pulsator level. Pulsator Loosen Lock Adjustable legs 3. If the washer is level, the pulsator will be centered in the washer as shown in the figure. If the pulsator is not centered, level your washer by turning the front leveling feet clockwise or counterclockwise as necessary. Turn the front leveling feet clockwise to raise the washer, and counterclockwise to lower the washer. English - 15 8"+@8"+"8@64&3."/6 JOEE