Samsung WF431ABP/XAA User Manual (user Manual) (ver.1.0) (English) - Page 12
Installing your washer
UPC - 036725569195
View all Samsung WF431ABP/XAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
installing your washer 2. Check the inlet hose to ensure a washer is inside each fill hose. Cold Thread the inlet hoses to the HOT and COLD faucet connections. On the other end of the hose, check for one rubber washer per hose and attach each fill hose to the water valve. Make sure the hose with Hot printed on it is attached to the HOT faucet. Tighten by hand until snug, then two-thirds of a turn with pliers. For correct water use, connect both HOT and COLD water valves. If either or both are not connected, an "nF" (no fill) error can occur. Cold printed 3. Turn on the "HOT" and "COLD "water supply and check the water valve and the water supply connections for leaks. Hot Rubber Washer Hot printed 4. Plug the power cord into a 3-Prong, well grounded 120 volt 60 Hz approved electrical outlet protected by a 15amp fuse or comparable circuit breaker. Your washer is grounded through the third prong of the power cord when plugged into a three-prong grounded receptacle. 5. Slide your washer into position. 6. Level your washer by turning the leveling legs in or out as necessary by hand or by using the wrench included with your washer. When your washer is level, tighten the locking nuts using the wrench or (-) flathead screwdriver. Your washer must be leveled on all four sides. A carpenter's level should be used on all four corners of your washer. We recommend you recheck your washer after a dozen or so washes to makesure it's sitll level. Locking Nut Avoid damage to the legs. Do not move the Washer unless the Locking-nuts are fastened to the bottom of the Washer. Levelling Leg 12_ Installing your washer WF431ABP-03016A_EN.indd Sec2:12 2011-01-11 ¿ÀÈÄ 3:17:57