Samsung WF431ABP/XAA User Manual (user Manual) (ver.1.0) (English) - Page 22

maintaining your washer - parts

Get Samsung WF431ABP/XAA PDF manuals and user guides
UPC - 036725569195
View all Samsung WF431ABP/XAA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

maintaining your washer CLEANING THE EXTERIOR Turn off the water faucets after finishing the day's washing. This will shut off the water supply to your washer and prevent the unlikely possibility of damage from escaping water. Leave the door open to allow the inside of your washer to dry out. Use a soft cloth to wipe up all detergent, bleach or other spills as they occur. Clean the following as recommended below: Control Panel - Clean with a soft, damp cloth. Do not use abrasive powders or cleaning pads. Do not spray cleaners directly on the panel. Cabinet - Clean with soap and water. CLEANING THE INTERIOR Clean the interior of your washer periodically to remove any dirt, soil, odor, mold, mildew, or bacterial residue that may remain in your washer as a result of washing clothes. Failure to follow these instructions may result in unpleasant conditions, including odors and/or permanent stains on your washer or laundry. Hard water deposits may be removed, if needed. Use a cleaner labeled "Washer safe". CLEANING THE DISPENSERS You may need to clean the automatic dispenser cleaned periodically due to laundry additive buildup. 1. Pull out the detergent liquid holder from the detergent compartment. 2. Remove the siphon cap from the fabric softener and bleach compartments. 3. Wash all of the parts under running water. 4. Clean the dispenser recess with a soft brush. 5. Reinsert the siphon cap and push it firmly into place. 6. Push the dispenser back into place. 7. Run a Rinse+Spin cycle without any load in your washer. Siphon cap STORING YOUR WASHER Washers can be damaged if water is not removed from hoses and internal components before storage. Prepare your Washer for storage as follows: • Select the Quick Wash cycle and add bleach to the automatic dispenser. Run your washer through the cycle without a load. • Turn the water faucets off and disconnect the inlet hoses. • Unplug your washer from the electrical outlet and leave your washer door open to let air circulate inside the tumbler. • If your washer has been stored in below-freezing temperatures, allow time for any leftover water in your washer to thaw out before use. 22_ maintaining your washer WF431ABP-03016A_EN.indd Sec4:22 2011-01-11 ¿ÀÈÄ 3:18:02

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
22_
maintaining your washer
maintaining your washer
CLEANING THE EXTERIOR
Turn off the water faucets after finishing the day’s washing.
This will shut off the water supply to your washer and prevent the unlikely possibility of damage from
escaping water. Leave the door open to allow the inside of your washer to dry out.
Use a soft cloth to wipe up all detergent, bleach or other spills as they occur.
Clean the following as recommended below:
Control Panel – Clean with a soft, damp cloth. Do not use abrasive powders or cleaning pads. Do not spray
cleaners directly on the panel.
Cabinet – Clean with soap and water.
CLEANING THE INTERIOR
Clean the interior of your washer periodically to remove any dirt, soil, odor, mold, mildew, or bacterial
residue that may remain in your washer as a result of washing clothes.
Failure to follow these instructions may result in unpleasant conditions, including odors and/or permanent
stains on your washer or laundry.
Hard water deposits may be removed, if needed. Use a cleaner labeled “Washer safe”.
CLEANING THE DISPENSERS
You may need to clean the automatic dispenser cleaned periodically due to
laundry additive buildup.
1.
Pull out the detergent liquid holder from the detergent compartment.
2.
Remove the siphon cap from the fabric softener and bleach
compartments.
3.
Wash all of the parts under running water.
4.
Clean the dispenser recess with a soft brush.
5.
Reinsert the siphon cap and push it firmly into place.
6.
Push the dispenser back into place.
7.
Run a
Rinse+Spin
cycle without any load in your washer.
STORING YOUR WASHER
Washers can be damaged if water is not removed from hoses and internal components before storage.
Prepare your Washer for storage as follows:
•
Select the Quick Wash cycle and add bleach to the automatic dispenser. Run your washer through the
cycle without a load.
•
Turn the water faucets off and disconnect the inlet hoses.
•
Unplug your washer from the electrical outlet and leave your washer door open to let air circulate inside
the tumbler.
•
If your washer has been stored in below–freezing temperatures, allow time for any leftover water in your
washer to thaw out before use.
Siphon cap
WF431ABP-03016A_EN.indd Sec4:22
WF431ABP-03016A_EN.indd
Sec4:22
2011-01-11 ¿ÀÈÄ 3:18:02
2011-01-11
¿ÀÈÄ 3:18:02