Sanyo ABC-VW24A ABC-VW24A Owners Manual English & French - Page 15

Troubleshooting English Warning ¡If the device is still operating abnormally after inspecting the following, stop using the device to prevent accidents, unplug the power plug from the wall outlet and consult the place of purchase. ¡Do not attempt to repair at home as this may be dangerous. Condition Inspect Does not operate. ¡Is the power plug securely in the wall outlet? Repair ¡Place the power plug securely in the wall outlet. Smoke and odors are not removed. ¡Are the filter and pre-filter installed? ¡Has the plastic protector on the filter been removed? ¡Install the filter and pre-filter. ¡Remove the plastic protector on the filter. ¡Is the filter or pre-filter dirty? ¡Is the filter replacement lamp flashing? ¡Replace the filter or clean the pre-filter. ¡Is the air inlet dirty and blocked? ¡Clean the air inlet. The clean ¡Is the air very dirty? indicator is ¡Are any insecticides or cosmetic devices that continuously red. may trigger the sensor being used? ¡Ventilate the room. ¡Is the sensor sensitivity adjustment slide tab set ¡Set the sensor sensitivity adjustment slide tab to to "HIGH"? "Mid" or "LOW". The add water lamp is on. ¡Is there water in the tank? ¡Fill the tank with tap water. ¡Remove the tank and replace after waiting 20 seconds. The add water lamp is flashing. ¡It is time to replace the water. ¡The electrolyzed water function has not been used for an extended period of time. ¡Clean the electrolyzed water unit and replace the water in the tank. ¡Remove the tank and replace after waiting 20 seconds. Water is leaking. ¡Has the cap been placed correctly on the tank? ¡Retighten the cap correctly. There is an odor of chlorine. The sterile, electrolytic mist is not emitted. ¡Has the electrolyzed water unit been properly installed? ¡Install the electrolyzed water unit properly. ¡This is from the electrolyzed water and is not a malfunction. ¡Has the electrolyzed water unit and tank been properly installed? ¡Is the electrolyzed water button turned "Off"? ¡Is the water level in the electrolyzed water unit high? ¡Ensure that the installation is correct. ¡Press the electrolyzed water button to turn "On". ¡Replace the water in the electrolyzed water unit. The Electrolyzed Water lamp is ¡The Electrolyzed Water lamp flashes when cleaning the water to maintain its sterilizing flashing. effect. The Water Cleaning function operates once every 8 hours for about 4 minutes. Does not operate even when the air is dirty. ¡The automatic operation lamp (green) is flashing. ¡Is the sensor sensitivity adjustment slide tab set to "Mid" or "LOW"? ¡Is the air inlet dirty and blocked? ¡The sensor is configuring the air cleanliness standard. This is not a malfunction. ¡Set the sensor sensitivity adjustment slide tab to "Mid" or "HIGH". ¡Clean the air inlet. Specifications Power supply : 120 V / 60 Hz Current supply : 1.2 A Net weight : 15.9 lbs (7.2 kg) E-14