Sanyo CLM2472 Service Manual - Page 90
ure to, erform, roundin, Wiring Instructions for the Outdoor Unit, Fig. 31
View all Sanyo CLM2472 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
5-5. Wiring Instructions for the Outdoor Unit CAUTION G Be sure to correctly align inter-unit cables A, B, C and D. Outdoor unit A Terminal board 1 2 Indoor unit A 1 2 3 4 5 6 7 8 9 10 11 12 A is the indoor unit with refrigerant tubing that is connected to service valve A (top) of the outdoor unit. 123 Terminal board Inter-unit cables #14 (not provided) Label A A Indoor unit B B is the indoor unit with refrigerant tubing that is connected to service valve B (top) of the outdoor unit. 123 Terminal board Inter-unit cables #14 (not provided) Label B Power supply (conduit) Power: Single-phase, 230/208VAC 60HZ Power switch (not provided) Ground Power cable (not provided) (#12: Less than 85 ft.) B Indoor unit C C is the indoor unit with refrigerant tubing that is connected to service valve C (top) of the outdoor unit. 123 Terminal board Inter-unit cables #14 (not provided) Label C C Indoor unit D D is the indoor unit with refrigerant tubing that is connected to service valve D (top) of the outdoor unit. 123 Terminal board Inter-unit cables Label D #14 (not provided) D Be sure to perform grounding. Attach a ground wire to either the outdoor unit or indoor unit. If there is a grounding terminal inside the room, use the grounding screw inside the indoor unit. Be sure to apply the provided labels to both ends of the inter-unit cables to prevent miswiring. The units will not function if the wiring connections are incorrect. Inter Unit (conduit) Fig. 31 # ... AWG (American Wire Gauge) G Use a dedicated A/C circuit for power. G To make connections to the outdoor unit, remove the inspection panel and tubing panel. G Do not bring the inter-unit cables or power cable into contact with tubing or service valves. G Use outdoor unit cable fasteners and fasten the inter- unit cables at the location where the cables are doublesheathed. G Arrange the wiring so that the inter-unit cables are contained in the inspection panel and tubing panel, as shown in Fig. 31. 24