Sanyo DP55360 Owners Manual - Page 5
Getting Started - hdtv
View all Sanyo DP55360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
STAND REMOVAL AND WALL MOUNTING (OPTIONAL) Tools Needed: Phillips screwdriver IMPORTANT NOTE: Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish. Wall mounting of the HDTV must be performed by a skilled person. 1 Remove the two (2) screws holding the stand base cover and carefully dislodge. GETTING STARTED BATTERY INSTALLATION Install two (2) "AAA" batteries in the remote control. (Not included) To ensure safe operation, please observe the following precautions: • Replace both batteries at the same time. Do not use a new battery with a used battery. • There's a risk of explosion if a battery is replaced by an incorrect type. • Do not expose the Remote Control unit to moisture or heat. • Be sure to match the "+" and "-" signs on the batteries with marks inside the remote control. 2 Remove the four (4) screws securing the stand base to the HDTV. CAUTION: Hold the stand firmly as you remove the last screw. ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE Hook up your antenna or your cable service to the HDTV's ANT terminal with the use of a 75 OHM coaxial cable. NOTE: Keep your indoor antenna at least 3 ft. away from the television set and any other electronic equipment. 3 Use the screws that are threaded into the four (4) inserts on the back of your HDTV to secure it to an appropriate wall mounting kit. ANTENNA CABLE ANALOG / DIGITAL ANTENNA IN VESA standard interface: 400 x 400 Mounting screws measurements: M6 (6mm) Diameter, Length-12mm (maximum) NOTE: Wall mounting kit is not included. Need help? The tuner in this HDTV can receive: • Digital and Analog off air signals from an antenna • Analog or ClearQAM cable channels from a direct Cable TV connection. www.sanyoctv.com 1-877-864-9604 5