Sanyo H1340 Operating Instructions - Page 3

ACCESSORIES Please retain the carton and packing materials, as this is the best protection for the unit should it be necessary to return it for servicing Check the packing carefully for the following accessories (1) 1 x l#mounting bracket (used to fix unit to car, see installation method B) (2) 2 x 2#mounting bracket (used to fix unit to car, see installation method B) (3) 1 x 3#mounting bracket (used to fix unit to car, see installation method B) (4) 1 x right bracket (used for "GM" car) (5) 1 x left bracket (used for "GM" car) (6) 8 x screw 3x4mm (used to fix mounting bracket (l#, 2#, 3#) to unit, see installation method B) (7) 4 x quickie bolt 5x1 Omm (used to fix unit to car, see installation method A) (8) 1 x quickie bolt 5xl8mm (used to fix unit to car, see installation method A) (9) 1 x screw 2xl2mm (used to secure the front panel for anti-theft purposes) (10) 5 x hexagon nut (used to quickie bolt) (11) 4 x screw 4x1 Omm (used to right/left bracket) 6) (4& t2) 6 t3) & 14) @ 1#mounting bracket 2#mounting bracket 3#mounting bracket (5) (6) (7) 03) right bracket @m left bracket (9) (10) screw quickie bolt (11) quickie bolt a3 & screw hexagon nut screw CAUTION l This unit is designed to operate on 12 volts DC, negative ground electrical systems only l When fuse replacement is necessary, use only a 15 amp fuse Do not replace with a higher rated fuse If the fuse blows often, carefully check all electrical connections for any short circuits and have your car's voltage regulator checked also l Do not install the unit where it will be exposed to direct sunlight or hot air discharged from the car heater l Do not expose the unit to water or moisture l This AM/FM Radio with CD Player should not be adjusted or repaired by anyone except qualified service personnel If servicing is required, return the unit to an authorized SANYO mobile audio dealer l Changes or modifications not expressly approved by SANYO may void the user's authority to operate this equipment l This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation 1