Sanyo PDG-DSU30 Owner's Manual - Page 37
Problem: LED lighting message, not turn on until the lamp module has been replaced. To replace
UPC - 086483076596
View all Sanyo PDG-DSU30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Appendices not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in the "Replacing the Lamp". Problem: LED lighting message Message Standby (Input power cable) (Blue) POWER-LED (Red) Normal (Power on) Powering up (Warming up) Flashing(1 sec) Power off (Cooling-I: It can't accept any key at this status) Power off (Cooling-II: It can accept power key to turn on the projector) Error (Lamp failed) Error (Fan lock) Error (Over temp.) Note Flashing(0.5 sec) Flashing(1 sec) Flashing(0.5 sec) Flashing(1 sec) Flashing (0.5 sec on, 2 secs off) Steady light => No light => 36 English
36
English
Appendices
Message
POWER-LED
(Blue)
(Red)
Standby (Input power cable)
Normal (Power on)
Powering up (Warming up)
Flashing
(1 sec)
Power off (Cooling-I: It can’t ac-
cept any key at this status)
Flashing
(0.5 sec)
Power off (Cooling-II: It can
accept power key to turn on the
projector)
Flashing
(1 sec)
Error (Lamp failed)
Flashing
(0.5 sec)
Error (Fan lock)
Flashing
(1 sec)
Error (Over temp.)
Flashing
(0.5 sec on, 2 secs off)
not turn on until the lamp module has been replaced. To replace
the lamp, follow the procedures in the “Replacing the Lamp”.
Problem: LED lighting message
Steady light =>
No light =>
N
o
t
e