Sanyo PDG-DSU30 Owner's Manual - Page 47
Serial Control Interface, Operation
UPC - 086483076596
View all Sanyo PDG-DSU30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Appendices Serial Control Interface This projector provides a function to control and monitor the projector's operations by using the RS-232C serial port. Operation 1. Connect the specified RS-232C control cable to SERVICE PORT on the projector and serial port on the PC. 2. Launch a communication software provided with PC and setup the communication condition as follows: 3. Type the command for controlling the projector and then enter the "Enter" key. Example When you want to change the input to Computer, Type 'C' '0' '5' 'Enter'. Baud rate Parity check: Stop bit Flow control Data bit : 9600 bps : none : 1 : none : 8 Note • The default of the baud rate is set to 9600 bps. If an error occurs in the communication, change the serial port. • Enter with ASCII 64-byte capital characters and one-byte characters. 46 English ORDER RS-232C CONTROL CABLE RS-232C control cable can be ordered through your dealer. When ordering, give the following information to the dealer. ■ Model No. of your projector : PDG-DSU30 ■ RS-232C control cable : Service parts No. CH4200272G002