Sanyo PDG-DWL100 Owner's Manual - Page 13
Remote Control Battery Installation, Remote Control Operating Range, To ensure safe operation
UPC - 086483074875
View all Sanyo PDG-DWL100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Introduction Remote Control Battery Installation 1 Open the battery compartment lid. 2 Install new batteries into the compartment. 3 Replace the compartment lid. Two AAA size batteries For correct polarity (+ and -), be sure battery terminals are in contact with pins in the compartment. To ensure safe operation, please observe the following precautions : ■ Use two (2) AAA type batteries. ■ Always replace batteries in sets. ■ Do not use a new battery with a used battery. ■ Avoid contact with water or liquid. ■ Do not expose the remote control to moisture or heat. ■ Do not drop the remote control. ■ If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries. ■ Risk of an explosion if battery is replaced by an incorrect type. ■ Dispose of used batteries according to the instructions. ■ If the new battery are installed into the compartment within 3~4 hours, the remote control code will not be returned to default. ■ The original setting will be kept and will not be erased. Note Remote Control Operating Range Infrared Remote Point the remote control Receiver is provided toward the projector (In- on the top of the pro- frared Remote Receiver) jector. when pressing any button. Point the remote Maximum operating range control from obliquely for the remote control is above frared toward the InRemote Receiver about 39.4' (12m) and 60° in when operating the top of the projector. remote control. 39.4' (12m) Approx.30° 12 English