Sanyo PDG-DWL100 Owner's Manual - Page 17

Powering Off the Projector, If you wish to turn the projector back on, you must wait

Get Sanyo PDG-DWL100 - WXGA DLP Projector PDF manuals and user guides
UPC - 086483074875
View all Sanyo PDG-DWL100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Installation Powering Off the Projector 1. Press the "ON/STAND-BY" to turn off the projector lamp, you will see a message as below on the on-screen display. 2. Press the "ON/STAND-BY" again to confirm. 3. The cooling fan continues to operate for about 60 seconds for cooling cycle and the POWER LED will flash green. When the light starts flashing orange, the projector has entered standby mode. If you wish to turn the projector back on, you must wait until the projector has completed the cooling cycle and has entered standby mode. Once in standby mode, simply press "ON/STAND-BY" to restart the projector. 4. Disconnect the power cable from the electrical outlet and the projector. 5. Do not turn on the projector immediately following a power off procedure. 16 English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
16
English
Installation
Powering Off the Projector
1.
Press the “ON/STAND-BY” to turn off the projector lamp,
you will see a message as below on the on-screen display.
2.
Press the “ON/STAND-BY” again to confirm.
3.
The cooling fan continues to operate for about 60 seconds for
cooling cycle and the POWER LED will flash green. When
the light starts flashing orange, the projector has entered
standby mode.
If you wish to turn the projector back on, you must wait
until the projector has completed the cooling cycle and has
entered standby mode. Once in standby mode, simply press
“ON/STAND-BY” to restart the projector.
4.
Disconnect the power cable from the electrical outlet and the
projector.
5.
Do not turn on the projector immediately following a power
off procedure.