Sanyo PLC-XF47 Owners Manual - Page 77
Serial Control Interface, Operation, Functional Execution Command
UPC - 086483068959
View all Sanyo PLC-XF47 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Appendix Serial Control Interface This projector provides a function to control and monitor the projector's operations by using the RS-232C serial port. Operation 1 Connect a RS-232C serial cross cable to SERIAL PORT IN on the projector and serial port on the PC. (See p.11) 2 Launch a communication software provided with PC and setup the communication condition as follows: 3 Type the command for controlling the projector and then enter the "Enter" key. Example When you want to change the input to INPUT 2, Type 'C' '0' '6' 'Enter'. Baud rate Parity check Stop bit Flow control Data bit : 9600 / 19200 bps : none : 1 : none : 8 ✔Note: • The default of the baud rate is set to 19200 bps. If an error occurs in the communication, change the serial port and the communication speed (baud rate). •Enter with ASCII 64-byte capital characters and one-byte characters. Functional Execution Command Format The command is sent from PC to the projector with the format below; 'C' [Command] 'CR' Command: two charactors (refer to the command table below. -The projector decodes the command and returns the 'ACK' with the format below; 'ACK' 'CR' -When the projector can not decode the command, it returns with format below. '?' 'CR' Command C00 C01 C05 C06 C07 C08 C0D C0E C0F C10 C1C C1D C3A Function Turn the projector ON Turn the projector OFF (immediately OFF) Select Input 1 Select Input 2 Select Input 3 Select Input 4 Video mute ON Video mute OFF Aspect 4:3 Aspect 16:9 Menu ON Menu OFF Pointer RIGHT Command C3B C3C C3D C3F C46 C47 C4A C4B C5D C5E C5F C60 C89 C8E C8F C90 C91 Function Pointer LEFT Pointer UP Pointer DOWN Enter Zoom DOWN Zoom UP Focus DOWN Focus UP Lens shift UP Lens shift DOWN Lens shift LEFT Lens shift RIGHT Auto PC Adj. Keystone UP Keystone DOWN Keystone RIGHT Keystone LEFT 77