Sanyo PLC-XL51 Owner's Manual - Page 10

Part Names and Functions Side Terminal q w e r t y u i o !0 !1 !2 !3 !4 q LAN Connection Terminal Connect the LAN cable (refer to the owner's manual "Network Set-up and Operation"). w SERVICE PORT This jack is used to service the projector. e COMPUTER IN 1 Connect output signal from a computer, or RGB scart 21pin video output to this terminal (pp.16, 18). When the cable is of the longer variety, it is advisable to use this terminal and not COMPUTER IN 2/MONITOR OUT. r COMPUTER IN 2/MONITOR OUT This terminal is switchable and can be used for input from a computer or output to the other monitor. Set the terminal up as either Computer input or Monitor output properly. [Used for Monitor out, this terminal outputs only incoming signal from COMPUTER IN 1 terminal (pp. 16, 49)]. t COMPONENT IN Connect the component video output signal to these jacks (p.18). y WIRELESS INDICATOR Display the status of wireless network. Refer to the owner's manual "Network Set-up and Operation". u SD MEMORY CARD INDICATOR Display the status of SD memory card. When inserting SD memory card, the indicator lights, and when removing SD memory card, the indicator turns off. i SD MEMORY CARD SLOT Insert the SD memory card (not supplied) for Memory viewer operation (refer to the owner's manual of Memory Viewer function). o ALARM buttons Use these buttons when setting up the Alarm function (pp.56-57). !0 S-VIDEO IN Connect the S-VIDEO output from video equipment to this jack (p.17). !1 AUDIO OUT(VARIABLE) Connect an external audio amplifier to this jack (pp.1618). This terminal outputs sound from AUDIO IN terminal (!2 or !4). !2 AUDIO IN COMPUTER Connect the audio output (stereo) from a computer connected to e or r to this jack (pp.16, 18). !3 VIDEO IN Connect the composite video output from video equipment to VIDEO jack (p.17). !4 AUDIO IN Connect the audio output from video equipment connected to t, !0 or !3 to this jack. [When the audio output is monaural, connect it to L (MONO) jack (pp.1718). 10