Sanyo PLC-XL51 Owner's Manual - Page 49

Setting Ceiling When this function is set to "On," the picture is top/bottom and left/right reversed. This function is used to project the image from a ceiling-mounted projector. Rear When this function is set to "On," the picture is left/right reversed. This function is used to project the image to a rear projection screen. Terminal The COMPUTER IN 2/MONITOR OUT terminal on the back of the projector is switchable for computer input or monitor output (p.10). Select Computer 2 or Monitor Out with the Point 7 8 buttons. Computer 2......computer input Monitor Out......monitor out Terminal function is not available when Computer 2 to the input source is selected. Change the input source to the others (Computer1 or Video) so that the Terminal function is available (pp.27, 37-38). Auto setup This function enables Input search and Auto PC adjustment by pressing the AUTO SET button on the remote control. Settings for those functions can be altered as follows: Input search This function detects the input signal automatically. When finding a signal, the search will stop. Use the Point 7 8 buttons to select one of the followings. Off ...... Input search does not work. On1 ...... Input search works under the situation below. •When the AUTO SET button on the remote control is pressed. On2 ...... Input search works under the situation below. •When the projector is turned on with pressing the ON/STAND-BY button on the top control or on the remote control. (After the countdown) •When the AUTO SET button on the remote control is pressed. •When the current input signal is missed. ✳ ✳ If the No show or Freeze function is active, cancel it to activate the Input search. It is not available when On‑Screen menu is displayed. Auto PC adj. On . . . . . E nables Auto PC Adjustment when pressing the AUTO SET button on the remote control. Off . . . . . Disables Auto PC Adjustment. Ceiling Rear ✔Note: • Input search and Auto PC Adj. cannot be set to "Off" at the same time. • While Input search is set On1 or On2, the status of Input and Lamp are displayed every time the signal is switched. • Only the input source selected at the last time can be detected. • If the AUTO SET button on the remote control is pressed while Input search is on, Input search will stop and go back to the previous input signal. • The input source can be switched by pressing the COMPUTER, VIDEO, S-VIDEO, COMPONENT, or NETWORK button on the remote control while Input search is on. • Sync on Green signal does not support Input search. • Input search does not work for Wired/ Wireless Network input sources. • If the INPUT button on the top control is pressed while Input search is on, Input search will stop. • The Auto PC adjustment function can be operated directly with the AUTO PC button on the remote control even when Auto PC adj. is set to "Off" in the Auto setup setting. 49