Sanyo PLC-XU47 Owners Manual - Page 9

Part Names and Functions Rear Terminal Part Names and Functions q w e r t y COMPUTER IN 1 / COMPONENT IN AUDIO IN R L (MONO) VIDEO USB ✽ SERVICE PORT S-VIDEO COMPUTER / COMPONENT RESET COMPUTER IN 2 / MONITOR OUT AUDIO IN AUDIO OUT (VARIABLE) o iu q COMPUTER IN 1/ COMPONENT IN Connect output signal from a computer (Analog RGB) or video equipment (Component or RGB Scart) to this terminal. Optional cables are required when using this terminal as component input or RGB Scart 21-Pin Video input. (p15, 17) w SERVICE PORT This jack is used to service this projector. e AUDIO IN Connect the audio output from video equipment connected to r or i to this jack. (When the audio output is monaural, connect it to L (MONO) jack.) (p16) y AUDIO IN COMPUTER/ COMPONENT Connect the audio output (stereo) from a computer or video equipment connected to q or u to this jack. (p15, 17) u AUDIO OUT(VARIABLE) Connect an external audio amplifier to this jack. (p15, 16, 17) This terminal outputs sound from AUDIO IN terminal (e or y). i S-VIDEO Connect the S-VIDEO output from video equipment to this jack. (p16) r VIDEO Connect the composite video output from video equipment to VIDEO jack. (p16) t USB (Series B) Connect the USB port of your computer to this port when you wish to use the PAGE ed buttons on the remote control to scroll back and forth pages on the screen of the connected computer. (p15) o COMPUTER IN 2/ MONITOR OUT This terminal is switcheable and can be used for input from a computer or output to the other monitor. Set the terminal up as either Computer input or Monitor output properly. (Used for Monitor out, this terminal outputs only incoming signal from COMPUTER IN 1/ COMPONENT IN terminal.) (p15, 41) ✽ A built-in micro processor which controls this unit may occasionally malfunction and need to be reset. This can be done by pressing the RESET button with a pen, which will shut down and restart the unit. Do not use the RESET function excessively. 9