Sanyo PLV 70 Owners Manual - Page 12

CONNECTING PROJECTOR CONNECTING TO COMPUTER Cables used for connection (✽ = Cable or adapter is not supplied with this projector.) • VGA Cable (HDB 15 pin) ✽ • MAC Adapter (When connecting to Macintosh computer) ✽ • DVI-Digital Cable (for Single Link T.M.D.S.) ✽ • Audio Cable {Mini Plug (stereo) x 1} ✽ • BNC Cable ✽ • Control Cable for Serial Port IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA) Desktop type Laptop type Monitor Output Monitor Output Audio Output Serial port BNC Cable ✽ MAC Adapter ✽ Set slide switches according to chart below. VGA Cable ✽ DVI Cable ✽ Audio Cable ✽ (stereo) Control Cable for Serial Port Terminal COMPUTER AUDIO IN 1 or 2 CONTROL PORT COMPUTER IN ANALOG COMPUTER IN DIGITAL ANALOG INPUT 1 DIGITAL(DVI-D) R/C JACK AUDIO 1 RESET CONTROL PORT AUDIO 2 G B R H/V V VIDEO/Y Cb/Pb Cr/Pr INPUT 2 VIDEO/Y Cb/Pb Cr/Pr R-AUDIO-L S-VIDEO (MONO) INPUT 3 Terminals of a Projector x MAC ADAPTER ✽ Set switches as shown in table below depending on RESOLU- ON TION MODE that you want to use before you turn on projec- ON DIP 123456 tor and computer. OFF 1 2 3 4 56 13" MODE (640 x 480) ON ON OFF OFF OFF OFF 16" MODE (832 x 624) OFF ON OFF ON OFF OFF 19" MODE (1024 x 768) OFF ON ON OFF OFF OFF 21" MODE (1152 x 870) ON ON ON ON OFF OFF NOTE : When connecting cable, power cords of both a projector and external equipment should be disconnected from AC outlet. Turn a projector and peripheral equipment on before computer is switched on. 12