Sanyo PLV 70 Owners Manual - Page 15

BEFORE OPERATION KEYSTONE BUTTON Used to correct keystone distortion. (P20, 37) LENS SHIFT ON-OFF LENS KEYSTONE KEYS MENU SCREEN SELECT SCREEN BUTTON Used to select screen. (P30, 36) Operating Range Point Remote Control Unit toward projector (Receiver Window) whenever pressing any button. Maximum operating range for Remote Control Unit is about 16.4' (5m) and 60° in front and rear of a projector. VOLUME VOLUME IMAGE BUTTON 60° INPUT IMAGE Used to select image level. (P27, 33) INPUT IMAGE ZOOM BUTTON Used to adjust zoom. (P20) 1 1 2 2 3 4 3 Z F FOCUS BUTTON 16.4' (5 m) NO SHOW BUTTON MUTE ZOOM Z FOCUS F Used to adjust focus. (P20) Used to turn picture into black image. (P21) NO SHOW FREEZE AUTO PC ADJ. AUTO COLOR.M D D.ZOOM D WIRED REMOTE JACK D.ZOOM BUTTON Used to select DIGITAL ZOOM +/- mode and resize image. (P30) 16.4' (5 m) When using as Wired Remote Control, connect Remote Control Cable to this jack. Battery installation is required when using as Wired Remote Control. COLOR MANAGEMENT 60° BUTTON Used to operate COLOR MANAGEMENT. (P28, 34) Remote Control Batteries Installation 1 Remove battery compartment lid. Pull up lid and remove it. 2 Slide batteries into compartment. 3 Replace compartment lid. Two AA size batteries For correct polarity (+ and -), be sure battery terminals are in contact with pins in compartment. To insure safe operation, please observe following precautions : q Use (2) AA, UM3 or R06 type alkaline batteries. q Replace two batteries at same time. q Do not use a new battery with an used battery. q Avoid contact with water or liquid. q Do not expose Remote Control Unit to moisture, or heat. q Do not drop Remote Control Unit. q If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries. q Danger of explosion if battery is incorrectly replaced. q Dispose of used batteries according to batteries manufacturers instructions and local rules. 15