Sanyo PLV 70 Owners Manual - Page 38
To change code of Projector, To change code of Remote Control Unit - lamp replacement
View all Sanyo PLV 70 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
SETTING On start When this function is "On," projector is automatically turned on just by connecting AC Power cord to a wall outlet. Note ; Be sure to turn projector off properly (refer to section "TURNING OFF PROJECTOR" on P19). If projector is turned off in wrong steps, On Start function does not operate properly. Remote control This projector has two different remote control codes; factory-set normal code (Code 1) and secondary code (Code 2). This switching function prevents remote control operation mixture (jam) when operating several projectors or video equipment together. When operating projector in "Code 2," both projector and Remote Control Unit must be switched to "Code 2." To change code of Projector; Set Remote control in SETTING MENU to "Code 2." To change code of Remote Control Unit; Press both MENU and IMAGE buttons on Remote Control Unit together for over 10 seconds. After changing code, make sure Remote Control operates properly. To return to normal code (Code 1), operate both projector and Remote Control in ways above again. PJ-Net Organizer This function cannot be adjusted when not attach the PJ-Net organizer (optional part) to the projector. Refer to the owner's manual in the optional PJ-Net organizer. On start On Code 1 Press SELECT button at this icon to display other items. Press SELECT button at this icon to display previous items. Move pointer to item and then press POINT LEFT/RIGHT button(s). Lamp counter reset This function is used to reset Lamp Replace Counter. When replacing Projection Lamp, reset Lamp Replace Counter by using this function. Refer to page 40 for operation. Quit Closes SETTING MENU. Lamp counter reset On Code 1 Move pointer to Lamp counter reset and then press SELECT button. Message "Lamp replace counter reset?" is displayed. 38