Sanyo PLV-80L Instruction Manual, PLV-80L - Page 16
Before Operation, Remote Control Batteries Installation, Operating Range
UPC - 086483059254
View all Sanyo PLV-80L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
BEFORE OPERATION REMOTE CONTROL BATTERIES INSTALLATION 1 Remove battery compartment lid. Pull up lid and remove it. 2 Slide batteries into compartment. 3 Replace compartment lid. Two AA size batteries For correct polarity (+ and -), be sure battery terminals are in contact with pins in compartment. To insure safe operation, please observe following precautions : ● Use (2) AA, UM3 or R06 type alkaline batteries. ● Replace two batteries at same time. ● Do not use a new battery with an used battery. ● Avoid contact with water or liquid. ● Do not expose Remote Control Unit to moisture, or heat. ● Do not drop Remote Control Unit. ● If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries. ● Danger of explosion if battery is incorrectly replaced. ● Dispose of used batteries according to batteries manufacturers instructions and local rules. Operating Range Point Remote Control Unit toward projector (Infrared Remote Receiver) whenever pressing any button. 60° Maximum operating range for Remote Control Unit is about 16.4' (5m) and 60° in front and rear of a projector. 16.4' (5 m) 16.4' (5 m) 60° 16