Sanyo PLV-80L Instruction Manual, PLV-80L - Page 24

COMPUTER INPUT SELECTING INPUT SOURCE DIRECT OPERATION Select INPUT source by pressing INPUT button on Top Control or on Remote Control Unit. Select INPUT source by pressing INPUT 1, INPUT 2 or INPUT 3 button on Remote Control Unit. If projector cannot reproduce proper image, select correct input source through MENU OPERATION (see below). INPUT button Input 1 Input 2 Input 3 SELECTING COMPUTER SYSTEM WHEN SELECT INPUT 1 (COMPUTER INPUT TERMINALS ) 1 Press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT buttons to move a red frame pointer to INPUT Menu icon. 2 Press POINT UP/DOWN buttons to move a red arrow pointer to Input 1 and then press SELECT button. Source Select Menu will appear. 3 Move a pointer to source that you want to select and then press SELECT button. RGB (PC analog) When your computer is connected to INPUT 1 (ANALOG) terminal, select RGB (PC analog). RGB (Scart) When scart video equipment is connected to INPUT 1 (ANALOG) terminal, select RGB (Scart). RGB (PC digital) When your computer is connected to INPUT 1 (DIGITAL) terminal, select RGB (PC digital). RGB (AV HDCP) If a HDCP-compatible signal source is connected to the INPUT 1 (DIGITAL) terminal, select RGB (AV HDCP). NOTE; INPUT SOURCE changes if the INPUT 1 button on Remote Control Unit is pressed. INPUT MENU Input Input 1 Input 2 Input 3 Input 1 SVGA1 INPUT Menu icon Move a pointer (red arrow) to Input 1 and press SELECT button. Source Select Menu Move a pointer (red arrow) to source and press SELECT button. NOTE; HDCP (High-bandwidth Digital Content Protection) is a system for protecting digital entertainment content which is delivered by DVI (Digital Visual Interface) from being copied. The specification of HDCP is decided and controlled by Digital Content Protection, LLC. Should the specification be changed, this projector may not display the digital content protected by HDCP. 24