Sanyo PLV Z2 Owners Manual - Page 40

Setting Capture This function is used to capture the image being projected and use it for a starting-up display or interval of presentations. After capturing the projected image, go to the Logo function and set it as "User". Then the captured image will be displayed when turning on the projector next time or pressing the MY PICTURE (MY-P) button on the remote control. (p12) To capture the image, select [Yes]. To cancel the Capture function, select [No]. Ceiling When this function is "On," the picture is top/bottom and left/right reversed. This function is used to project the image from a ceiling mounting the projector. Rear When this function is "On," the picture is left/right reversed. This function is used to project the image to a rear projection screen. Power management For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the input signal is interrupted and no button is pressed for 30 seconds or more. When the input signal is interrupted and no button is pressed for 30 seconds or more, the timer display with the message "No signal" appears on the screen. The count-down starts for 5 minutes. When the count-down time has elapsed, the lamp will be turned off to cool itself down. The POWER indicator is flashing red during this cooling-off period. The next performance depends on setting as follows. On ··· When the lamp has been fully cooled down, the POWER indicator changes to green flashing. In this condition, the projection lamp will be turned on if the input signal is reconnected or any button on the top control or remote control is pressed. Off ··· The Power management function is canceled. Capture Ceiling Rear This arrow indicates that there are previous items. Select this item and press the Point Up button to go to the previous item. Power management Power off confirmation The confirmation dialog box to turn off the projector is displayed with this function ON. NOTE G Before capturing an image, select Standard in the Image Select Menu to capture a proper image. (p27, 36) G A signal from a computer can be captured up to XGA(1024 x 768). If selecting 1280 x 1024 at Display area in the PC Adjust Menu (p35), then the image cannot be captured. G A signal from video equipment can be captured except for 720p, 1035i, 1080i, and a signal compatible with HDCP. G When capturing the image that has been adjusted by the Keystone function, the adjustment data is automatically reset and the projector captures an image without keystone adjustment. G If the Capture function fails to capture an image, the On-Screen Menu returns to the Capture item. G If capturing a signal which is not able to be captured, an exclamation mark appears and the function will not be available. G If cancelling the Capture function in the middle of operation, the last captured image will be deleted. Time left until lamp off 40