Sanyo PLV Z2000 Owners Manual - Page 49
Lamp Replacement - bulb
View all Sanyo PLV Z2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Lamp Replacement When the projection lamp of this projector reaches its end of life, the LAMP REPLACE indicator emits yellow light. If this indicator lights yellow, replace the lamp with a new one promptly. The time when the LAMP REPLACE indicator should light is depending on the lamp mode. This indicator lights yellow when the projection lamp reaches its end of life. Maintenance and Cleaning Top Control CAUTION Allow the projector to cool, for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot. CAUTION For continued safety, replace the lamp with the same type lamp. Do not drop the lamp or touch the glass bulb! The glass can shatter and may cause injury. Follow these steps to replace the lamp. 1 Turn off the projector and unplug the AC power cord. Let the projector cool for at least 45 minutes. 2 Loosen the screw that secures the lamp cover, and then open the lamp cover. 3 Loosen the two (2) screws that secure the lamp. Pull out the lamp by using the built in handle. 4 Replace the lamp with a new one and secure it with the two (2) screws. Make sure that the lamp is set properly. Put the lamp cover back and secure it with the screw. 5 Connect the AC power cord to the projector and turn on the projector. 6 Reset the Lamp replacement counter (p.50). Screw Lamp Cover Handle Screws Lamp ORDER REPLACEMENT LAMP Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer. ● Model No. of your projector: ● Replacement Lamp Type No.: PLV-Z2000 POA-LMP114 (Service Parts No. 610 336 5404) 49