Sanyo XP30 Instruction Manual, PLC-XP30 - Page 45

APPENDIX CONFIGURATIONS OF THE TERMINALS COMPUTER INPUT-1 TERMINAL (ANALOG) Terminal : HDB15-PIN Connect the display output terminal of the computer to this terminal with the VGA Cable (supplied). When connecting the Macintosh computer, the MAC Adapter (supplied) is required. Pin Configuration 54 32 1 10 9 8 7 6 15 14 13 12 11 1 Red Input 9 +5V Power 2 Green Input 10 Ground (Vert.sync.) 3 Blue Input 11 Sense 0 4 Sense 2 12 DDC Data 5 Ground (Horiz.sync.) 13 Horiz. sync. 6 Ground (Red) 14 Vert. sync. 7 Ground (Green) 15 DDC Clock 8 Ground (Blue) COMPUTER INPUT-1 TERMINAL (DIGITAL) Terminal : DVI 24-pin Connect the display output terminal of the computer to this terminal with the DVI cable (not supplied). Pin Configuration 12345678 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 1 T.M.D.S. Data2- 9 T.M.D.S. Data1- 17 T.M.D.S. Data0- 2 T.M.D.S. Data2+ 10 T.M.D.S. Data1+ 18 T.M.D.S. Data0+ 3 T.M.D.S. Data2 Shield 11 T.M.D.S. Data1 Shield 19 T.M.D.S. Data0 Shield 4 No Connect 12 No Connect 20 No Connect 5 No Connect 13 No Connect 21 No Connect 6 DDC Clock 14 +5V Power 22 T.M.D.S. Clock Shield 7 DDC Data 15 Ground (for +5V) 23 T.M.D.S. Clock+ 8 No Connect 16 Hot Plug Detect 24 T.M.D.S. Clock- CONTROL PORT CONNECTOR Terminal : Mini DIN 8-PIN Connect control port (PS/2, Serial or ADB port) on your computer to this terminal with the Control Cable (supplied). Pin Configuration 876 5 43 21 PS/2 1 ----2 CLK 3 DATA 4 GND 5 ----6 ----7 GND 8 ----- Serial R X D --------GND RTS T X D GND GND ADB ----ADB ----GND GND MAC ADAPTER Set the switches as shown in the table below depending on the RESOLUTION MODE that you want to use before you turn-on the projector and computer. ON OFF ON DIP 123456 123456 13" MODE (640 x 480) ON ON OFF OFF OFF OFF 16" MODE (832 x 624) OFF ON OFF ON OFF OFF 19" MODE (1024 x 768) OFF ON ON OFF OFF OFF 21" MODE (1152 x 870) ON ON ON ON OFF OFF 45