Sanyo XU101 Instruction Manual, PLC-XU101 - Page 56
Appendix, Troubleshooting
UPC - 086483067921
View all Sanyo XU101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Appendix Troubleshooting Before calling your dealer or service center for assistance, check the items below once again. -Make sure you have properly connected the projector to peripheral equipment as described on page15-17. -Make sure all equipment is connected to AC outlet and the power is turned on. -When you operate the projector with a computer and it does not project an image, restart the computer. Problem: No power Image is out of focus. No image Image is Left/Right reversed. Image is Top/Bottom reversed. No sound - Solutions - Plug the power cord of the projector into the AC outlet. - See if the POWER indicator lights red. - Wait 90-120 seconds after the projector is turned off when turning the projector back on. The projector can be turned on after the POWER indicator turns red. (See on page 20.) - Check the WARNING indicator. If the WARNING indicator lights red, the projector cannot be turned on. (See on page 51.) - Check the projection lamp. (See page 54.) - Unlock Key lock for the projector Key lock function. (See page 47.) - Adjust focus of the projector. (See page 23.) - Provide proper distance between the projector and the projection screen. (See page 14.) - Check the projection lens to see if it needs cleaning. (See page 53.) - Moving the projector from a cool to a warm place may result in moisture condensation on the projection lens. In such cases, leave the projector off and wait until condensation evaporates. - Check the connection between your computer or video equipment and the projector. (See pages 15-17) - See if the input signal is correctly output from your computer. Some laptop computers may need to change the setting for monitor output when connecting to a projector. See your computer's instruction manual for the setting. - It takes about 30 seconds to display an image after turning on the projector. - See if the selected system is corresponding with your computer or video equipment. (See pages 27 and 37) - Select correct input source once again through menu operation. (See pages 26 ,35 and 36) - Make sure the temperature is not out of the specified Operating Temperature {41 ˚F ~ 95 ˚F (5 ˚C ~ 35 ˚C)} . - Check the Ceiling / Rear function. (See page 45.) - Check the Ceiling function. (See page 45.) - Check audio cable connection from audio input source. - Adjust the audio source. - Press the Volume+ button. (See page 23.) - Press the Mute button. (See page 23.) - Is the image projected? You will hear the sound only when the image is projected. 56