Schwinn 450 Elliptical Assembly and Owner's Manual - Page 50
Condition/Problem, Things to Check, Solution
View all Schwinn 450 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Condition/Problem No speed/RPM reading, Console displays "Please Stride" error code Console shuts off (enters sleep mode) while in use Things to Check Check data cable integrity Solution All wires in cable should be intact. If any are cut or crimped, replace cable. Check data cable connections/orientation Check magnet position (requires shroud removal) Check Speed Sensor (requires shroud removal) Check electrical (wall) outlet Check connection at front of unit Check data cable integrity Check data cable connections/orientation Reset machine Check magnet position (requires shroud removal) Check Speed Sensor Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Magnet should be in place on pulley. Speed sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. Make sure unit is plugged into a functioning wall outlet. Connection should be secure and undamaged. Replace adapter or connection at unit if either are damaged. All wires in the cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. Magnet should be in place on pulley. Contact Customer Care for further assistance. 50