Home » Seagate Manuals » Hard Drives » Seagate ST800FM0022 » Manual Viewer

Seagate ST800FM0022 Pulsar Serial ATA Product Manual - Page 2

Revision history - drives

View all Seagate ST800FM0022 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 2 highlights

Revision Rev. A Date 04/05/10 Revision history Sheets affected or comments Initial release. © 2010 Seagate Technology LLC. All rights reserved. Publication number: 100596473, Rev. A. April 2010 Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Pulsar and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. All other trademarks or registered trademarks are the property of their respective owners. No part of this publication may be reproduced in any form without written permission of Seagate Technology LLC. Call 877-PUB-TEK1(877-782-8651) to request permission. When referring to drive capacity, one gigabyte, or GB, equals one billion bytes and one terabyte, or TB, equals one trillion bytes. Your computer's operating system may use a different standard of measurement and report a lower capacity. In addition, some of the listed capacity may be used for formatting and other functions, and thus will not be available for data storage. Seagate reserves the right to change, without notice, product offerings or specifications.

Section	Page
1.0 Introduction	7
1.1 About the Serial ATA interface	8
2.0 Drive specifications	9
2.1 Specification summary tables	9
2.2 Formatted capacity	11
2.2.1 LBA mode	11
2.3 Default logical geometry for ATA based systems	11
2.4 Performance, Recording and interface technology	11
2.4.1 Interface technology	11
2.4.2 Recording technology	11
2.4.3 Performance	12
2.5 Physical characteristics	12
2.6 Access time	13
2.7 Time to Ready	13
2.8 Power specifications	14
2.8.1 Power consumption	14
2.8.1.1 Typical current profiles	18
2.8.2 Conducted noise	18
2.8.3 Voltage tolerance	18
2.9 Environmental specifications	19
2.9.1 Ambient temperature	19
2.9.2 Temperature gradient	19
2.9.3 Humidity	19
2.9.3.1 Relative humidity	19
2.9.3.2 Wet bulb temperature	19
2.9.4 Altitude	19
2.9.5 Shock	19
2.9.5.1 Operating shock	19
2.9.5.2 Nonoperating shock	19
2.9.6 Vibration	20
2.9.6.1 Operating vibration	20
2.9.6.2 Nonoperating vibration	20
2.10 Electromagnetic immunity	20
2.11 Reliability	21
2.11.1 Annualized Failure Rate (AFR) and Mean Time Between Failures (MTBF)	21
2.11.2 Reliability specifications	21
2.12 Agency certification	22
2.12.1 Safety certification	22
2.12.2 Electromagnetic compatibility	22
2.12.3 FCC verification	22
2.13 Environmental protection	23
2.13.1 European Union Restriction of Hazardous Substances (RoHS) Directive	23
2.13.2 China Restriction of Hazardous Substances (RoHS) Directive	23
2.14 Corrosive environment	24
3.0 Configuring and mounting the drive	25
3.1 Handling and static-discharge precautions	25
3.2 Configuring the drive	26
3.3 Serial ATA cables and connectors	26
3.4 Drive mounting	27
3.5 Cooling	28
4.0 Serial ATA (SATA) interface	29
4.1 Hot-Plug compatibility	29
4.2 Serial ATA device plug connector pin definitions	30
4.3 Supported ATA commands	31
4.3.1 Identify Device command	33
4.3.2 Set Features command	40
4.3.3 S.M.A.R.T. commands	41
5.0 Seagate Technology support services	43
Index	45
A	45
C	45
D	45
E	45
F	45
G	45
H	45
I	45
K	45
L	46
M	46
N	46
O	46
P	46
Q	46
R	46
S	46
T	47
U	47
V	47

Match case Limit results 1 per page

Revision history

Publication number: 100596473, Rev. A. April 2010

Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in

the United States and/or other countries. Pulsar and SeaTools are either trademarks or registered

trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or

other countries. All other trademarks or registered trademarks are the property of their respective

owners.

No part of this publication may be reproduced in any form without written permission of Seagate

Technology LLC. Call 877-PUB-TEK1(877-782-8651) to request permission.

When referring to drive capacity, one gigabyte, or GB, equals one billion bytes and one terabyte, or

TB, equals one trillion bytes. Your computer's operating system may use a different standard of

measurement and report a lower capacity. In addition, some of the listed capacity may be used for

formatting and other functions, and thus will not be available for data storage. Seagate reserves the

right to change, without notice, product offerings or specifications.

Revision

Date

Sheets affected or comments

Rev. A

04/05/10

Initial release.