Sennheiser ew 100 G2 Instructions for Use - Page 62

º¾ Connecting the amplifier/mixing console The EM 100 G2's audio outputs are available as an XLR-3M socket ᕨ and a ¼" (6.3 mm) jack socket ᕩ, allowing you to simultaneously connect two units (e.g. amplifier, mixing console). The adjusted audio output level is common for both sockets. ̈ Connect the amplifier/mixing console to the XLR-3M socket ᕨ or the ¼" (6.3 mm) jack socket ᕩ. For detailed information on balanced and unbalanced connection, please refer to the section "Connector assignment" auf Seite 43. ̈ Via the operating menu, adapt the level of the audio output (AF OUT) to the input of the amplifier or mixing console (see: „Adjusting the audio output level (receivers only)" on page 33). Service interface The service interface µ is only required for servicing purposes. µ 19" rack adapter and antenna mount (accessories) ƻ ƺ Ƽ For mounting one or two receivers into a 19" rack, you require the GA 2 rack adapter. The GA 2 rack adapter consists of: y 2 rack mount "ears" ƺ y 1 connecting bar ƻ y 1 connecting plate Ƽ y 2 covering plugs ƽ for antenna holes y 12 recessed head screws M 3x6 ƽ y 2 recessed head screws M 6x10 When mounting only one receiver into a rack, you can use the AM 2 antenna mount (available as an accessory) to mount the transmitter's antenna connection to the front of the GA 2 rack adapter. The AM 2 antenna mount consists of : ƾ y 2 BNC extension cables (screw-in BNC socket ƾ to BNC connector ƿ) y 2 plains washers ƿ y 2 nuts 15