Sennheiser ew 100 G2 Instructions for Use - Page 64
Inserting and replacing the batteries, Connecting units to the audio output - bodypack
View all Sennheiser ew 100 G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
º¾ º ³ EK 100 G2 bodypack receiver Inserting and replacing the batteries For powering the EK 100 G2 bodypack receiver, you can either use two 1.5 V AA size batteries or the rechargeable Sennheiser BA 2015 accupack. ̈ Press the two unlocking buttons ᕩ and open the battery compartment cover ᕨ. ̈ Insert the two batteries or the BA 2015 accupack as shown in the diagram on the left. Please observe correct polarity when inserting the batteries/ accupack. ̈ Close the battery compartment. The battery compartment cover ᕨ locks into place and clicks. Note: For accupack operation of the receiver, only use the BA 2015 accupack In order to ensure optimum operational reliability. For charging the accupack, only use the L 2015 charger. Both the accupack and the charger are available as accessories. The accupack is fitted with an integrated sensor which is - via a third contact - monitored by the electronics of the receiver and the charger. The sensor is necessary for the following control purposes: y The taking into account of the different voltage characteristics of primary cells (batteries) and accupacks. The battery status indications on the displays, the transmission of transmitter battery status information to the rack-mount receivers and the switch-off thresholds at the end of the operating time are corrected correspondingly. Due to the missing sensor, individual rechargeable battery cells will not be identified as accupacks. y The monitoring of the accupack temperature during charging in the L 2015 charger. y The prevention of improper charging of inserted primary cells (batteries). Due to the missing sensor, individual rechargeable battery cells will also not be charged in the L 2015 charger. Connecting units to the audio output You can connect a PA system or a recording unit (e.g. video camera) to the EK 100 G2 bodypack receiver. ̈ Connect one of the supplied line output cables to the recording unit. ̈ Connect the 3.5 mm jack plug to the audio output (AF OUT) ᕡ. ̈ Lock the 3.5 mm jack plug by screwing down the coupling ring. ̈ Via the operating menu, adapt the level of the audio output (AF OUT) to the input sensitivity of the connected unit (see: „Adjusting the audio output level (receivers only)" on page 33). 17