Sharp AF-R100CX AF-R100CX , AF-R120CX , AF-R140CX Operation Manual - Page 13

HOW TO OPERATE ENERGY SAVER During normal operation, the thermostat automatically controls cooling and the fan runs continuously. When the ENERGY SAVER is selected, the thermostat automatically controls cooling and the fan automatically stops when the compressor is not operating. (Fan will stop 30 seconds after the compressor stops.Even after the fan stops, the fan will rotate for 2 minutes, every maximum 20 minutes, to detect room temperature.) Procedure Pad Display / Indicator During cooling operation 1 Touch ENERGY SAVER pad. ENERGY SAVER • ENERGY SAVER indicator will light. 2 To cancel, touch ENERGY SAVER pad again. ENERGY SAVER • ENERGY SAVER indicator will go off. NOTE: ENERGY SAVER cannot be set during FAN ONLY mode operation. TO CHANGE AIR FLOW DIRECTION Adjust the louvers to change the direction of air flow for uniform and efficient cooling of the room. Horizontal louvers Adjusts UP/DOWN air flow Vertical louvers Adjusts LEFT/RIGHT air flow EXHAUST If air in your room is stale, set the EXHAUST lever to the OPEN position. This will exhaust stale air to the outside. The EXHAUST lever should normally be kept in the CLOSED position during cooling for maximum efficiency. CLOSED EXHAUST Lever OPEN 13