Sharp AF-R100CX AF-R100CX , AF-R120CX , AF-R140CX Operation Manual - Page 17

HOW TO OPERATE OPERATING WITH THE REMOTE CONTROL TRANSMITTER POWER ON/OFF TEMP. TEMP. SELECTOR SET TIMER/OFF POWER ON / OFF button Push to start or stop the operation. TEMPERATURE setting button TEMP. ---Raise temp. setting 1°F at a time. TEMP. ---Lower temp. setting 1°F at a time. SELECTOR button Push to change fan speed, or to select fan only mode. Fan speed selections are shown to the right. HIGH COOL MED COOL LOW COOL FAN ONLY SET TIMER / OFF button Push to set delay "OFF" timer during operation. NOTE: • The "ON" TIMER cannot be set with the remote control. It can only be activated by the TIMER ON/OFF pad on the unit's control panel ( See page 14 ). • The time setting will change as you push the button. The display will change as follows; Preset(0.5h) Previous setting 0.5h 1.0h 1.5h 10h CL(cancel) 12h 11h • The last OFF time setting is memorized by the unit and will appear on the display when the button is pushed. • The timer will be set, 5 seconds after the SET TIMER / OFF button is pushed for the last time. • If you wish to cancel the timer, push the SET TIMER / OFF button again after the time is set or, push the SET TIMER / OFF button until CL (cancel) appears on the display. A double beep will sound when the timer is cancelled. To Change the Temperature Setting When the ON / OFF Timer Is In Use 1. Push a TEMPERATURE setting button. The current set temperature will be recalled on the unit's display. 2. Use the TEMPERATURE setting buttons to set the new temperature. The new set temperature will show on the display for 5 seconds and return to the time display. 17