Sharp AN-PHCM20 Installation Instructions - Page 9

INSTALLATION INSTRUCTIONS CEILING BRACKET AN-PHCM20 FIGURE 11 DETAIL OF POSITIONING ASSEMBLY CEILING PLATE PLASTIC CEILING PLATE TRIM COVER LOCKING NUT AND HORIZONTAL POSITION ADJUSTMENT HORIZONTAL TILT ADJUSTMENT VERTICAL POSITION ADJUSTMENT STEP 8 INSTALL THE PLASTIC TRIM COLLAR 8.1 The plastic trim collar may be used as a cosmetic concealment of the positioning adjustment knuckle assembly and the audio and video signal cables. 8.2 The slit side of the collar enables the installer to spread the collar enough to place it over the adjustment knuckle. It will curve back by its own spring action to wrap around itself enough to close the gap. (See Fig. 12) 8.3 If the projector is hung at a sharp angle, you may trim the collar for a better fit. (See Fig. 13) FIGURE 12 FIGURE 13 DO NOT RUN THE AC POWER CORD INSIDE THE PLASTIC TRIM COLLAR. ALL WIRING MUST COMPLY WITH THE NEC AND ALL LOCAL BUILDING, ELECTRIC AND SAFETY CODES. NOTE: IN THE EVENT YOU WISH TO USE THE SHARP ADJUSTABLE EXTENSION ACCESSORY IN CONJUNCTION WITH THE CEILING MOUNTING BRACKET, PLEASE REFER TO THE INSTALLATION INSTRUCTION MANUAL INCLUDED IN THE EXTENSION TUBE PACKAGE. PAGE 9